Page 60 of 92
Chapter: 6. Trouble Shooting
The information in the red box on previous page, shows the quality of the signals.
• Link to Transceiver; shows the internal communication status between display unit and transceiver
unit. Errors in this usually refer to a failure in cabling between the display unit and transceiver unit, but
can also point to a failure inside the transceiver cabinet. (See “Installation problems” on page 57 for
more information).
• Temperature will indicate a failure on the temperature sensor. This can be an early warning of other
problems.
• Signal Longitudinal & Signal Transversal; these indicate bad or no results from the sets of
longitudinal or transversal beams. This may be caused by system failure or bad acoustic conditions. If
the problem persists, the self diagnostics should be used to nd out if the system has a problem.
The other information on the status screen is a collection of information which may be observed and
manipulated with the various screen softkey selections. As a reference, it will often be more convenient
to observe the various settings together on this screen than to cycle from screen to screen to check on the
softkey texts.
To Next Page
Loading...
