›
Release the connector
and remove it from the
bulb.
›
Turn the light bulb and
take it out.
›
Push the new light bulb
into the light so that
the guide lugs on the
light bulb and the asso-
ciated openings in the
light are in alignment.
›
Turn the bulb clock-
wise
to secure.
›
Attach the connector to the bulb, ensuring it clicks
into place.
›
Reinstall the lamp and screw it on.
›
First insert the cover in the outer bumper area.
›
Press the cover in towards the centre of the
bumper until it clicks into place.
Rear turn signal
›
Remove the cover with
the bracket from the
tool kit.
›
Unscrew
screws
A and
remove the lamp.
›
Press the lock mecha-
nisms on the connec-
tor and remove the
connector.
›
Turn and remove the
socket with the bulb.
›
Change the bulb in the
socket.
›
Push the base with the
new light bulb into the
luminaire so that the
guide lugs on the base
and the associated
openings in the lumin-
aire are ush.
›
Turn the socket clock-
wise
to secure.
›
Insert the connector into the light until it clicks into
place.
›
Insert the lamp with the cones screws into the
openings B in the body.
NOTICE
Risk of damage to the electrical system!
▶
Make sure that the lines between the lamp and the
body are not pinched when the lamp is inserted.
›
Screw on the lamp.
›
Fit the cover of the light, ensuring it clicks into
place.
48
Lighting, windscreen wipers and washers › Replace light bulbs
To Next Page
Loading...
Need help?
General
