136
SJ1044 TH, SJ1044 THS, SJ1056 TH, SJ1056 THS, SJ1256 THS
230790ABA
Section 5 – Procedures 250 Hour or Quarterly Routine Maintenance
4. Apply a thin layer of engine oil to the new oil filter
gasket.
5. Screw on new filter by hand until the gasket is
touching then tighten to a torque of 7-9 ft.-lb. (10-
12 Nm).
6. Clean up any oil that may have spilled during this
procedure.
7. Refill engine with new oil through the fill area.
Refer to Table 2.3 for engine oil specifications.
Engine Oil
Fill Cap
Figure 19 Engine Oil Fill Cap
8. Start engine and allow it to run for 30 seconds
then stop the engine.
9. Check for oil leakage.
10. Check engine oil level on dipstick and add oil if
needed.
Engine Oil
Dipstick
Figure 20 Engine Oil Dipstick Location
11. Close the engine compartment cover then latch to
secure in place.
NOTE
Refer to your local/national regulations on how to
dispose of used filter and oil.
To Next Page
Loading...
