185
SJ1044 TH, SJ1044 THS, SJ1056 TH, SJ1056 THS, SJ1256 THS
230790ABA
Non-Routine Maintenance Section 5 – Procedures
5.6-10 Cable Track Replacement
If the cable track (5) or one of its hydraulic hoses
require replacement, the cable track assembly must be
removed from inside the boom. The cable tracks are
removed through the front access hole (3).
If removal of the carrier assembly is necessary, the
cable tracks should be removed first.
M62283AA
1
2
3
4
7
5 6
Figure 140 Cable Track General Assembly
1. Auxiliary Hydraulic Hoses
2. Tilt Cylinder Hydraulic Hoses
3. Front Access Hole
4. Upper and Lower Guide Brackets
5. Cable Tracks
6. Carrier Assembly
7. Side Access Holes
Preparation:
1. Place the boom in a horizontal (0°) position.
2. Shut down the machine.
3. Turn the main power disconnect switch off. Lock
out the switch.
Cable Track Removal
The right-hand cable track carries the fork tilt hydraulic
hoses. The left-hand cable track carries the auxiliary
hydraulic hoses.
Both cable tracks are removed in the same manner.
M62285AA
Figure 141 Cable Track Removal
Procedure:
WARNING
Escaping pressurized fluid from a hydraulic
pressure leak can damage your eyes, penetrate
the skin and cause serious injury. Use proper
personal protection at all times. Loosen the fitting
slowly to relieve pressure.
1. Mark and disconnect the fork tilt hydraulic hoses
or remove auxiliary hoses from the clamps from
the side of the boom (depending on which cable
track is being removed). Be aware there could be
residual pressure in the hoses.
2. Remove the protective hose sleeve. If
disconnecting the auxiliary hoses, remove the
quick-disconnect ends.
To Next Page
Loading...
