64 smart CX01
7.14.2 Setting RAPS Mode
Select RAPS-Modus to configure RAPS:
Update The receiver channel list will only be updated.
Config The receiver will be set to factory defaults. The channel list will be
created completely new (similar to the first installation, see section
“Initial Start-Up”, page 22).
Setup Here you can set the RAPS transponder manually.
Attention!
Change the RAPS transponder only after regarding advice from
smart. If you change it apart from that, RAPS cannot work correctly
anymore.
To activate the desired mode, select Start and press OK.
7.14.3 Enabling Automatic RAPS Updates
Select Auto RAPS-Scan, to set - using the keys und - whether the
channel list should be updated always at shut down (On) or not (Off). Factory
setting is Auto RAPS-Scan Off.
7.15 Remove USB Device safely
1. Select in the menu Tools the submenu Remove USB device and press OK.
2. Move highlight on the button OK and press OK to deactivate the USB stor-
age device
Move highlight on the button Cancel and press OK to cancel the deactiva-
tion.
7.16 Software Version
The submenu Information of the menu Tools displays the current version
number of the smart CX01 software.
7.17 Factory Settings
If you erroneously saved wrong settings or if you want to pass on the receiver
without your settings, then you can reset the receiver to the factory settings
(reset):
To Next Page
Loading...