52 smart CX01
7.1.3.2 Motor Antenna
At LNB Freq, select the value
corresponding to the used LNB.
Default value is a universal LNB
with 9750 - 10600 MHz.
At Motor Type, select the used control signal technology. Select between
DiSEqC 1.2 and USALS
13F
14
(depending on the used motor). The submenu item
Motor Setting states different settings depending on your previous selec-
tion.
7.1.3.2.1 DiSEqC 1.2
Select Delete All to delete all previously set satellite positions.
Select Motor Setting and press OK to open the submenu Motor Setting:
To set various antenna positions:
1. Select Satellite to se-
lect the satellite to
which the following
settings should apply.
2. Select Transponder to select the transponder that should be decisive for
the antenna position (usually the transponder that is used to send your
preferred channel).
3. Select Pos No. & Save to determine a position number at which the re-
spective satellite (i.e. the respective antenna position) should be saved.
4. Select Go to X to call a position from which you want to make the selec-
tion (the value Reference is the zero position).
5. Select Save and turn the antenna to the west or east by using the keys
and . Search for maximum values of signal strength and signal
quality (are displayed at the lower screen edge).
6. Then press OK to save the found position. A query will be displayed.
14
As compared to 1.0 and 1.1, DiSEqC1.2 offers the additional possibility of rotor control, USALS =
Universal Satellites Automatic Location System (particularly simple motor antenna control)
To Next Page
Loading...
