Smart Electronic CX01 - System Settings and Functions; OSD (On Screen Display) Settings; Hide OSD; OSD Transparency

Extended Settings and Functions
62 smart CX01
7.9 OSD16F
17
Setting
7.9.1 Hide OSD
 Using the keys and , set the number of seconds after which the
OSD should be hidden. You may set values from 1 to 10 seconds.
Default value is 5s (factory setting).
7.9.2 OSD Transparency
 Select transparency of the on-screen menu by using the keys and
.
You may set values from 0% (OFF) (no transparency) to 40% (almost trans-
parent). Default value is OFF.
7.10 LNB Supply Voltage at LNB IN
1. Select in the menu System Setup the submenu Other and press OK.
2. Select LNB Power, to switch on /off the LNB supply voltage at LNB IN using
the keys und .
7.11 Automatic Standby Function

Based on current EC regulations, this receiver is equipped
with an energy saving system. After three hours, the receiv-
er will automatically switch to energy save mode (energy
consumption of less than 0.5 W) unless a function is trig-
gered via remote control during such period (e.g. volume
change or switching of channels). You can deactivate the
automatic standby function via the menu.
1. Select in the menu System Setup the submenu Other and press OK.
2. Select Auto Standby to switch on or switch off the automatic standby func-
tion, using the keys and (factory setting is Auto Standby On).
7.12 Simultaneous Playback of Picture and Sound
Asynchrony between the image and the sound signals might for example occur
in your home cinema system due to the use of long cables. Your smart CX01
17
OSD = On Screen Display