Installation
8. Installation
8.1 Selecting the installation location
Before installing the scanner, you should select a suitable installation location.
A suitable, stable base (bench, tabletop etc.) should be chosen as an installation location.
If you install the computer required for operating the scanner underneath the worktop, the
available worktop area should be at least 1.1 m x 0.75 m (front width x depth). If you plan to also
place the computer on the worktable, the area must be enlarged corresponding to the dimensions
of the computer.
The selected workplace should, if possible, face away from windows or strong artificial light, as
excessively strong external light can lead to undesirable reflections on the monitor that can
interfere with the functioning and results of the optical scanner in extreme cases.
8.2 Unpacking and scope of delivery
Inspect the external packaging for visible damage as soon as you take delivery of the scanner. If
you notice that the packaging is damaged, inform the delivering forwarder and your specialist
dealer immediately.
The device is delivered in a strong outer box on a wooden pallet. After removing the straps, open
the upper folding lid of the box. The box contains a foam piece that protects the scanner, which is
packed below during transport.
First, pull the foam piece upwards out of the box. You can then lift off the whole box upwards.
The net weight of the scanner is approx. 23 kg.
Always observe the following instructions to lift the scanner properly out of the
packaging and position it at its location of use.
Two people must lift the device out of the packaging and place it on the prepared,
intended workplace.
Be sure to transport the scanner (while still on the pallet) as closely as possible to the
workplace to avoid longer transport distances.
The scanner accessories can be found at the base of the packaging.
Check that the scope of delivery is complete.
To Next Page
Loading...