Smart Optics Activity 850 - Figure 46: Bite Registration Symbol; Figure 47: Information Window; Figure 48: Squeeze Bite Alignment Prescan

Scanning procedure
42
Figure 46: “bite registration" symbol
You are then prompted to position the bite registration and give the measurement a name.
Once you have given the measurement a name and confirmed with "OK", a new information
window will appear.
Figure 47: Information window
Confirm with "Yes", and the device will immediately commence with the 3D scan based on the
selection created in the main scan (see Fig. 37).
After confirming the message with "No" , the prescan is started and you can then newly define
the selection for the bite registration in the prescan image (see Fig. 49)
Figure 48: Squeeze bite alignment prescan
Next the 3D scan is performed as usual with the following symbol: