Basic information about the device
Individual measurements:
After completing the scan definition, the software automatically calculates a scan program for
recording the positions specified by the operator and starts these. The positions provided in the
scan program are started up by the positioning unit and a 3D measurement is performed.
When scanning adjacent tooth stumps, it is usually necessary to measure the stumps in isolation
without the adjacent stumps, as otherwise the interdental area cannot be captured by the 3D
sensor.
The software will therefore prompt you to present the relevant tooth stumps individually and
freely, i.e. to remove all other stumps from the saw cut model.
Matching and data storage:
The recorded individual measurements are grouped together in the "Matching" mode.
The finished data set is then saved on the hard disk of the computer.
Visualization:
When the matching process is complete, the scan result is displayed on the monitor so that you
can directly assess the result visually.
Operating controls
To Next Page
Loading...