C H A P T E R 2
Installing your interactive projector
9 smarttech.com/kb/170295
l Install the dry-erase board and the projector straight, level and plumb to the wall.
l Select a dry-erase board with no bezel or with a bezel thickness of less than 3 mm above the
board surface. Bezels thicker than 3 mm above the board surface disrupt finger touch
performance.
I M P O R T A N T
Do not install map rails on any surface you select to project your image on. You must also
remove any existing map rails on the wall or dry-erase board before you use your interactive
projector.
l Select a dry-erase board that is flat. See the following procedure for more information.
To measure the flatness of a dry-erase board
1. Place a six-foot carpenter’s level horizontally across the dry-erase board.
2. Locate where the level is furthest away from the board surface, and then measure the distance.
Measure the flatness of the surface on both sides of the dry-erase board.
To Next Page
Loading...
