C H A P T E R 9
Connecting your room control system to your interactive projector
84 smarttech.com/kb/170295
Field Description
Cooling The projector is cooling.
Confirm off Confirm off is a non-selectable power state that is returned during
stage one of the two-button Off sequence.
Idle The projector is off but still receiving power (Standby mode).
Source selection controls
You can use source selection controls to switch input sources. The source type selected determines
which commands can be accepted.
The following commands inform you of the current source selection settings:
Command Response Available in Standby
mode
get input input=[current selected projector
source input]
Yes
get videoinputs videoinputs=[list of available projector
source inputs]
Yes
The following command controls the source selection settings.
Command Command target range Response
set input [target] =vga1
=Composite
=HDMI
=Next
=None
input=[target]
The following table describes the source selection response fields.
Field Description
VGA1 Switches source to the VGA 1 input connector.
Composite Switches source to the Composite video connector.
HDMI Switches source to the HDMI input port.
Next Switches the input to the next possible source.
None A non-selectable value that appears when you enter a “get input”
command while the projector is in Standby mode.
To Next Page
Loading...
