C H A P T E R 8
Remotely managing your interactive projector
78 smarttech.com/kb/170295
N O T E S
l The first time you enable the password settings, the default password value is four numbers,
for example, 1234.
l The maximum allowable password length is four numbers or letters.
l If you forget the projector password, refer to Accessing the service menu on page 70 to set the
projector setting to factory defaults.
Simple Network Management Protocol (SNMP)
Your interactive projector supports a list of SNMP commands as described in the management
information base (MIB) file. You can download this file by browsing to smarttech.com/software and
clicking the MIB files link in the Hardware section for the LightRaise interactive projector. The SNMP
agent supports SNMP version 1. Upload the MIB file to your SNMP management system application,
and then use it as described in your application’s user guide.
To Next Page
Loading...
