C H A P T E R 2
Installing your interactive projector
13 smarttech.com/kb/170295
3. Compare your measurements to the chart which appears on page 12 of the SLR 60wi installation
guide (smarttech.com/kb/170259), and select a row in the table that is smaller than your
available width and height. This determines the installation height of the projector mounting
bracket from the top of the projected image.
I M P O R T A N T
You need at least 2" (5 cm) clearance space above the top mounting holes. See the LightRaise
60wi interactive projector mounting template (smarttech.com/kb/170271) for more information
about ceiling clearances.
Routing the cables
Follow these instructions to route and secure the cables to the wall.
To connect the cables:
1. Route the cables through the top of the boom and down its length before you connect them to the
projector.
To Next Page
Loading...
