SMART LightRaise 60wi - Network Settings

C H A P T E R 8
Remotely managing your interactive projector
75 smarttech.com/kb/170295
Submenu setting Description
Lamp Mode Adjusts lamp brightness to Standard or Economy. Standard
displays a high-quality, bright image. Economy increases the lamp
life by decreasing the brightness of the image.
Auto Power Off Sets the length of the auto power off countdown timer between 1 and
240 minutes. The timer begins to count down when the projector no
longer receives a video signal. The timer finishes when the projector
enters Standby mode. Select 0 to turn off the timer.
High Speed Fan Adjusts the speed of the projector’s fan. Select Normal or High .
N O T E
Use the High setting when the projector’s temperature is high or the
altitude is above 6000’ (1800 m).
VGA1 Assigns an alternative name to your VGA 1 input, which appears
when you select the VGA 1 input.
HDMI Assigns an alternative name to your HDMI input, which appears
when you select the HDMI input.
Composite Assigns an alternative name to your Composite video input, which
appears when you select the Composite video input.
Emergency Alert Turns the on-screen alert broadcast message on or off. When
enabled, this message displays over the current projected image.
Alarm Message Displays an on-screen emergency notification message (maximum
60 characters).
Network settings
This menu allows you to use or not use Dynamic Host Control Protocol (DHCP) and to set the
network-related addresses and names when DHCP is not used.
Submenu setting Description
DHCP Determines if the projector’s IPaddress and other network settings
are dynamically assigned by a DHCPserver or manually set.
l
On allows the network’s DHCP server to assign a dynamic IP
address to the projector.
l
Off allows you to manually set the projector’s IP address and
other network settings.
IP Address Displays or allows you to set the projector’s IP address in values
between 0.0.0.0 and 255.255.255.255.
Subnet Mask Displays or allows you to set the projector’s subnet mask number in
values between 0.0.0.0 and 255.255.255.255.