C H A P T E R 3
Using your interactive projector
31 smarttech.com/kb/170295
l
N O T E
The center of the image is offset 1.75" to the left from the center of the mounting bracket with a
tolerance of ± 2". See the LightRaise 60wi interactive projector installation template
(smarttech.com/kb/170271) for more information.
l When you move the projector forward or backward on the boom to make the image larger or
smaller, you might need to tilt or turn the projector slightly to keep the image square. Loosen the
ball joint lever slightly to aid in this adjustment.
l To fine-tune the image, you might need to repeat all steps described in the installation document
in smaller increments.
Using your interactive pen
The interactive projector includes two interactive pens that can be used to draw or write in digital ink
at the same time. You can also use one interactive pen while you’re using your finger to touch the
surface and interact with your computer. Each pen has a charging port and a status light to help you
understand its status.
Interactive pen components
The following diagram and table describe the components of the interactive pens.
Component Description
1 On/Off switch
N O T E
You can leave the switch On all the time, including when charging. The pen
automatically turns off when not in use to prolong battery life.
2 USB receptacle for charging
To Next Page
Loading...
