C H A P T E R 9
Connecting your room control system to your interactive projector
87 smarttech.com/kb/170295
These commands inform you of the current VGA source settings.
Command Response
get frequency frequency=[current frequency offset setting]
get tracking tracking=[current tracking offset setting]
These commands control the appearance of your VGA source. These settings are unavailable when
the projector is in Standby mode or when the VGA source is disconnected. See Value-based
command methods on page 82 for setting absolute and adjustment commands.
Command Command target range Response
set frequency [value] =-5 to =5 frequency=[value]
set tracking [value] =0 to =63 tracking=[value]
Audio controls
These commands control your projector’s internal audio amplifier, which affects sound passed
through the projector to your external audio system (not included). Audio output controls aren’t defined
by the video source. These settings are unavailable when the projector is in Standby mode.
These commands inform you of the current audio output settings.
Command Response
get volume volume=[current volume setting]
get micvolume micvolume=[current microphone volume setting]
get mute mute=[current mute setting]
get volumecontrol volumecontrol=[current volume control setting]
get cc cc=[current closed caption setting]
get lineoutenable lineoutenable=[current state of line out
get micenable micenable=[current state of microphone]
get speakerenable speakerenable=[current state of the built-in speakers]
get micboostenable micboostenable=[current state of the microphone boost]
These commands control your projector’s audio amplifier settings. See Value-based command
methods on page 82 for setting absolute and adjustment commands.
Command Command target range Response
set volume [target] =0 to =40 volume=[value]
To Next Page
Loading...
