C H A P T E R 6
Maintaining your interactive projector
52 smarttech.com/kb/170295
6. Use the Phillips screwdriver to loosen the captive screw on the lamp module, and disconnect the
lamp module’s power plug. Use the handle on the lamp module to gently slide the lamp module
out and remove it from the projector.
7. Put the old lamp module in a secure container and handle it gently until you recycle or dispose of
it.
I M P O R T A N T
Recycle or dispose of the lamp module according to your local waste authority.
To put the new lamp module into the projector
1. Remove the new lamp module from its packaging.
2. Carefully place the lamp module into the projector using the handle on the top of the module, and
then tighten the captive screw with the Phillips screwdriver.
C A U T I O N
Do not over-tighten the screws.
3. Connect the lamp module’s power plug into the power receptacle.
4. Place the lamp protection film over the slot, carefully replace the lamp cover and then tighten the
captive screw.
To Next Page
Loading...
