C H A P T E R 3
Using your interactive projector
24 smarttech.com/kb/170295
Setting Use Notes
Touch Enables touch and pen interaction
on either VGA1, HDMI or VGA1
&HDMI.
The default is VGA1 &HDMI.
Only change this setting if you
want touch and pen interaction
active on only one video source
(VGA or HDMI).
I M P O R T A N T
This setting must match the
current video input or there will
be no touch function.
Auto Power Off (minutes) Sets the length of the auto power-
off countdown timer between 1 and
240 minutes.
The default is 120 minutes.
The timer begins to count down
when the projector no longer
receives a video signal. When
the timer finishes, the projector
enters Standby mode.
Select 0 to turn off the timer.
Zoom Adjusts the zoom to the center of
the image in or out from 0 to 30.
The default is 0.
Zooming in cuts off the outer
edges of the source video.
I M P O R T A N T
SMART recommends you
leave Zoom at the default
setting of 0. Adjusting this
setting can affect touch
function.
Projector ID Displays the projector’s unique ID
within your organization’s network.
You can set the projector ID from
0to999.
The default is 0.
You can refer to this number
when using the network remote
management feature (see
Remotely managing your
interactive projector on page 73).
To Next Page
Loading...
