Appendix B
53 smarttech.com/kb/170549
Appendix B: Remotely managing your system
through an RS-232 serial interface
Serial interface settings 54
Projector programming commands 55
Projector power state controls 55
Command/response definitions 55
Field definitions 56
Source Application Selection 56
Command/response definitions 56
Field definitions 57
Video control 58
Command/response definitions 58
Field definitions 60
Audio control 63
Command/response definitions 63
Field definitions 64
Network information 65
Command/response definitions 65
Field definitions 66
System information 67
Command/response definitions 67
Field definitions 69
Service Information 73
Command/response definitions 73
Field definitions 74
Unknown command 76
This appendix includes detailed instructions on how to set up your computer or room control
system to remotely manage your SMARTBoard interactive whiteboard system settings through an
RS-232 serial interface.
By connecting a computer or room control system to the interactive whiteboard, you can select
video inputs, start up or shut down your interactive whiteboard system and request information
such as projector lamp use, current settings and network addresses.
To Next Page
Loading...
Need help?
General
