SMART M600i6 - System Information; Command;Response Definitions

APPENDIX B
REMOTELY MANAGING YOUR SYSTEM THROUGH AN RS-232 SERIAL INTERFACE
67 smarttech.com/kb/170549
Field Possible values Description
target primarydns
= Range: 0.0.0.0 to
255.255.255.255
Target primary dns
MAC address
xx-xx-xx-xx-xx-xx
The device’s MAC address.
System information
Use these commands to set your system information.
Command/response definitions
Command Response Powered off
set autosignal [target] autosignal=[current] no
get autosignal autosignal=[current] no
set lampreminder
[target]
lampreminder=
[current]
no
get lampreminder lampreminder=
[current]
no
set highbrightness
[target]
highbrightness=
[current]
no
get highbrightness highbrightness=
[current]
no
set autopoweroff
[target]
autopoweroff=[current] no
get autopoweroff set
zoom [target]
autopoweroff=[current] no
set zoom [target] zoom=[current] no
get zoom zoom=[current] no
set projectorid [target] projectorid=[current] no
get projectorid projectorid=[current] no
set aspectratio [target] aspectratio=[current] no
get aspectratio aspectratio=[current] no
set projectionmode
[target]
projectionmode=
[current]
no