SMART M600i6 - Field Definitions

APPENDIX B
REMOTELY MANAGING YOUR SYSTEM THROUGH AN RS-232 SERIAL INTERFACE
66 smarttech.com/kb/170549
Command Response Powered off
get gateway gateway=[current] yes
set primarydns [target] primarydns=[current] yes
get primarydns primarydns=[current] yes
get macaddr macaddr=[MAC
address]
yes
Field definitions
Field Possible values Description
current netstatus l connected
l disconnected
Current status of the network interface
current network l on
l off
Current status of the network module and the
VGA output
target network l on
l off
Enable/Disable network module and VGA
output
current dhcp l = on
l = off
Enable/Disable for DHCP Networking
target dhcp l on
l off
Enable/Disable for DHCP Networking
current ipaddr
Range: 0.0.0.0 to
255.255.255.255
Current IP address (static or dhcp assigned)
target ipaddr
= Range: 0.0.0.0 to
255.255.255.255
Set to static IP Address
current subnetmask
Range: 0.0.0.0 to
255.255.255.255
Current subnet Mask
target subnetmask
= Range: 0.0.0.0 to
255.255.255.255
Target subnet Mask
current gateway
Range: 0.0.0.0 to
255.255.255.255
Current gateway
target gateway
= Range: 0.0.0.0 to
255.255.255.255
Target gateway
current primarydns
Range: 0.0.0.0 to
255.255.255.255
Current primary dns