CHAPTER 4
MAINTAINING YOUR INTERACTIVE WHITEBOARD SYSTEM
29 smarttech.com/kb/170549
4. Replace the lamp cover.
5. Connect the power cable to the wall outlet.
6.
Press the Power button once on the remote control to confirm that the projector is
operating and that the lamp module is correctly installed.
7. Put the old lamp module in a secure container, and handle it gently until you recycle it.
To finish the projector lamp module installation
1. Turn on the projector.
2. Adjust the projector image if necessary (see
Adjusting the image
on page19).
3. Access the service menu to reset the lamp hours (see
Resetting the lamp hours
below).
4. Activate the projector’s alert e-mails and lamp warnings if they’ve been deactivated (see
E-
mail alerts
on page51 and
Control panel
on page46).
Resetting the lamp hours
After you replace the lamp module, you need to access the projector service menu to reset the
lamp hours. To prevent accidental errors, only a system administrator should perform this
procedure.
NOTE
Always reset the lamp hours after you replace the lamp, because lamp service reminders are
based on the current hours of use.
To reset the lamp hours
1. Using the remote control, press the following buttons quickly to access the service menu:
Down, Up, Up, Left, Up.
CAUTION
Do not adjust any settings in the service menu other than those listed in this guide. Changing
other settings can damage or affect the operation of your projector and may invalidate your
warranty.
To Next Page
Loading...
Need help?
General
