APPENDIX B
REMOTELY MANAGING YOUR SYSTEM THROUGH AN RS-232 SERIAL INTERFACE
76 smarttech.com/kb/170549
Field
Possible Values
Description
target statereporting
l
= on
l
= off
Target state reporting value
current poweroverride
l
on
l
off
A power override forces the projector to
remain on when the command is received. This
command isn’t persistent and isn’t stored to
non-volatile memory (cleared on power cycle).
When this mode is enabled, the power button
on the remote control and the ECP, if present,
must not turn off the projector.
This command must also be added to the
service menu so the user can disable it from the
OSD.
target poweroverride
l
= on
l
= off
Sets the power override
Unknown command
If an unknown command is received, the projector sends the following response to the user (there
is a space between “invalid” and “cmd”).
>dummycommand 2134
invalid cmd=dummycommand 2134
To Next Page
Loading...
