APPENDIX B
REMOTELY MANAGING YOUR SYSTEM THROUGH AN RS-232 SERIAL INTERFACE
58 smarttech.com/kb/170549
> set input=next
input = composite
> get videoinputs
videoinputs = vga1, composite, hdmi1
> get usb1source
usb1source = vga1
> get usb2source
usb2source = hdmi1
> set usb2source=hdmi1
usb2source = hdmi1
>
Video control
Use these commands to change your projector's video output controls. The range of values used
for these commands should match the range displayed in the on-screen display (OSD). The
firmware must handle videofreeze and videomute states correctly. A change should be made to
ensure that videofreeze and videomute are mutually exclusive.
Command/response definitions
Command Response Responds when powered off
set displaymode [target] displaymode=[current] no
get displaymode displaymode=[current] no
set brightness [target] brightness=[current] no
get brightness brightness=[current] no
set contrast [target] contrast=[current] no
get contrast contrast=[current] no
set frequency [target] frequency=[current] no
get frequency frequency=[current] no
set tracking [target] tracking=[current] no
get tracking tracking=[current] no
set saturation [target] saturation=[current] no
get saturation saturation=[current] no
set tint [target] tint=[current] no
To Next Page
Loading...
Need help?
General
