APPENDIX B
REMOTELY MANAGING YOUR SYSTEM THROUGH AN RS-232 SERIAL INTERFACE
55 smarttech.com/kb/170549
4. Type commands to configure your settings.
NOTES
o
To see a list of commands available in the current operating mode, type ? and then
press ENTER.
o
If you’re using a terminal emulation program, turn on your program’s local echo setting
to see characters as you type them.
Projector programming commands
This section documents the projector programming commands and responses.
Projector power state controls
Use these commands to determine the projector power state and related controls.
Command/response definitions
Command Response Responds when powered off
on powerstate=[power state] yes
off [off option] powerstate=[power state] yes
get powerstate powerstate=[power state] yes
To Next Page
Loading...
Need help?
General
