SMART M600i6 User Manual

APPENDIX B
REMOTELY MANAGING YOUR SYSTEM THROUGH AN RS-232 SERIAL INTERFACE
63 smarttech.com/kb/170549
brightness=65
>set brightness +5
brightness=70
>set brightness -15
brightness=55
>
All video commands also have an optional source specification. For example, to set the brightness
of a specific source, use the following command.
EXAMPLE
>set brightness = 65
brightness=65
>set brightness vga1 = 65
brightness vga1 = 65
This sets the brightness of the VGA1 source whether the projector is on this source or not.
Audio control
Use these commands to set audio output controls. The range of values used for these commands
should match the range shown in the on-screen display (OSD).
Command/response definitions
Command Response Powered off
set volume [target] volume=[current] no
get volume volume=[current] no
set mute [target] mute=[current] no
get mute mute=[current] no
set volumecontrol
[target]
volumecontrol=
[current]
no
get volumecontrol volumecontrol=
[current]
no
set cc [target] cc=[current] no
get cc cc=[current] no

SMART M600i6 Specifications

General

Brand	SMART
Model	M600i6
Category	Interactive whiteboard
Language	English