SMART M600i6 - Page 70

APPENDIX B
REMOTELY MANAGING YOUR SYSTEM THROUGH AN RS-232 SERIAL INTERFACE
62 smarttech.com/kb/170549
Field Possible values Description
target blue
l + val
l – val
l = 0 to 100
The ranges must match the OSD ranges.
current blue Range: 0 to 100 The ranges must match the OSD ranges.
target cyan
l + val
l – val
l = 0 to 100
The ranges must match the OSD ranges.
current cyan Range: 0 to 100 The ranges must match the OSD ranges.
target magenta
l + val
l – val
l = 0 to 100
The ranges must match the OSD ranges.
current magenta Range: 0 to 100 The ranges must match the OSD ranges.
target yellow
l + val
l – val
l = 0 to 100
The ranges must match the OSD ranges.
current yellow Range: 0 to100 The ranges must match the OSD ranges.
target videofreeze
l = on
l = off
Video freeze on/off
current videofreeze
l = on
l = off
Video freeze on/off
current displayhide
l normal
l frozen
l muted
Matches the three states of the Hide button on
the remote control.
target displayhide
l normal
l frozen
l muted
l next
Set the mode directly or move from one state
to the next sequentially.
Use the above commands to set the property to an absolute value or to adjust the current value.
EXAMPLE
>get brightness
brightness=55
>set brightness = 65