SMART M600i6 - Page 76

APPENDIX B
REMOTELY MANAGING YOUR SYSTEM THROUGH AN RS-232 SERIAL INTERFACE
68 smarttech.com/kb/170549
Command Response Powered off
get projectionmode projectionmode=
[current]
no
set startupscreen
[target]
startupscreen=[current] no
get startupscreen startupscreen=[current] no
set restoredefaults restoredefaults=
[current]
yes
get lamphrs lamphrs=[current] yes
set lamphrs [target] lamphrs=0 yes
get syshrs syshrs=[current] yes
get resolution resolution=[current] no
get nativeaspectratio nativeaspect=[native] no
get fwverddp fwverddp=[current] yes
get fwvernet fwvernet=[current] yes
get fwvermpu fwvermpu=[current] yes
get serialnum serialnum=[current] yes
get fwverecp fwverecp=[current] yes
set language [target] language=[current] no
get language language=[current] no
set groupname [target] groupname=[current] no
get groupname groupname=[current] no
set projectorname
[target]
projectorname=
[current]
no
get projectorname projectorname=
[current]
no
set locationinfo [target] locationinfo=[current] no
get locationinfo locationinfo=[current] no
set contactinfo [target] contactinfo=[current] no
get contactinfo contactinfo=[current] no
get modelnum modelnum=UF70, or
modelnum=UF70w
no
Returns the actual model of the projector