SMART M600i6 - Page 79

APPENDIX B
REMOTELY MANAGING YOUR SYSTEM THROUGH AN RS-232 SERIAL INTERFACE
71 smarttech.com/kb/170549
Field Possible values Description
target projectionmode
l
= front
l
= ceiling
l
= rear
l
= rear ceiling
The ranges must match the OSD settings.
current
projectionmode
l
= front
l
= ceiling
l
= rear
l
= rear ceiling
The ranges must match the OSD settings.
target startupscreen
l
= smart
l
= usercapture
l
= preview
The ranges must match the OSD settings.
current startupscreen
l
= smart
l
= usercapture
l
= preview
The ranges must match the OSD settings.
current reset
l
done Sent once you reset the projector.
current lamphrs
l
0 to 5000 Current lamp hour usage
target lamphrs 0 Clear the current lamp hour usage. The only
valid value is 0.
current resolution
l
800x600
l
1024x768
l
…
l
no signal
Current resolution of the input. If no signal is
detected, “resolution=no signal” appears.
native aspect ratio 4:3 for SMART UF70,
16:10 for SMART
UF70w
Native aspect ratio. DLP resolution of the
projector. Returns the actual native aspect ratio
of the projector.
current fwverddp x.x.x.x Firmware version
current fwvernet x.x.x.x Network processor version
current fwvermpu x.x.x.x MPU version
current prjserialnum xxxxxxxxxxxxx Projector serial number
current fwverecp x.x.x.x ECP version, if present