BT-T080R User’s Manual
- 47 -
Other problems:
Problems Possible reasons Solutions
LED isn’t light and printer
doesn’t work.
The printer is not
connected with the power
correctly;
The printer isn’t turned
on.
Connect the printer with the power.
Turn on the printer.
The printer doesn’t work
after receiving
commands.
Printer is in error status.
The communication cable
is not connected well.
Interface setting is wrong.
Remove all errors(＊);
Make sure the communication cable is connected correctly.
Print a self-test page and set the interface again according to
information on it.
Table 7.2.4 Other problems index
Note: Paper near end alarm acts only as a prompt for users, not error status. Therefore when this alarm is
given, print task can still be sent.
To Next Page
Loading...
