SNBC BT-T080R - Appendix; Appendix 1 Self-Test Page

BT-T080R User’s Manual
- 48 -
Appendix
Appendix 1 Self-test page
Print the self-test page in the following steps: Turn off printer power, then press the FEED button for at
least 1 second while turning on the printer. The printer will start to print a self-test page. (Take the model
with 203DPI/USB interface as an example, and the self-test page is shown as follows).
***BT-T080R TEST FORM***
Boot Firmware :FV1.000
Main Firmware :FV1.020
H/W Parameters
H/W ID :BT-T080R(U)1
Flash Memory Size :1M Bytes
Flash Logos/Fonts :64K Bytes
Resolution :203×203DPI
Print Width(Max） :80mm
Print Width(Real) :78mm
Fixed Left Margin :2mm
Fixed Right Margin :0mm
Print Speed(MAX) :150mm/s
Dark Scale :110
Cutter :Enabled
Paper Roll Width :80mm
Presenter :Disabled
Paper type :without blackmark
CRCommand :Disabled
CurrentFont :Font0
Communication Interface
Rx Buffer Size :4K Bytes
Interface Type :USB_BT-T080R_1
Resident Fonts
Font0 (12X24) :English
Font1 ( 9X17) :English
Current Code Page :PC437
Code Pages
:PC437,PC850
:PC852,PC858
:PC860,PC863
:PC865,PC866
:1252,Katakana
:More in