Chapter 4: Measurements and Calculations 89
Meas. & Calcs
Vascular Calculations
Vascular Measurements
The following table shows the transducers and exam types that provide vascular measurements.
Carotid vascular measurements may be performed and saved to the patient report. The specific
measurements that can be stored to the patient report are provided in the following table. For
definitions of acronyms, see “Acronyms” on page 211.
View or Repeat
Saved
Measurement
1 Highlight the desired measurement from the calculations menu.
The saved measurement is shown at the bottom of the calculation
menu.
2 Press Select key or the Caliper key to select the measurement.
3 Repeat the measurement.
The new results are displayed in the measurement and calculation
data area. You can compare the active measurement to the saved
measurements.
4 To save a new measurement, select Save from the on-screen menu, or
press the Enter key.
Note: This will save the new measurement to the patient report and
overwrite the previously saved measurement.
Delete
Measurement
1 Highlight the measurement.
2 Select Delete from the on-screen menu.
This will remove the last saved measurement from the patient report.
Warning: Verify the patient information, date, and time settings are accurate.
Before starting a new calculation, start a new patient exam to delete the previous
measurements. See “New Patient” on page 41.
Table 11: Transducer and Exam Types for Vascular
Transducer Exam Types
C11 Vascular
HST Vascular
L25 Vascular
L38 Vascular
To Next Page
Loading...
