58 Chapter 3: Imaging
Imaging
Annotation
Note: In a single image, you can only enter annotation in one row across the top of a frozen or live image. In
Dual image you can only enter text in one row across the bottom of each section of the screen. Annotation is
available in both live imaging and on a frozen image. You cannot annotate on a saved image.
Enter Text
1 Press the Tex t key or the Spacebar key.
In a single image a green data entry cursor is displayed in the upper
left corner.
2 Use the keyboard to enter, delete, or modify text.
• Press the Backspace key to delete characters to the left of the
cursor.
• Press the Space key to add spaces between words or replace
characters with blank spaces to the right of the cursor.
• Press the Arrow keys to move the cursor to the left or right.
• Press the Enter key to return the cursor to the beginning of the
line of text.
• Press the Delete key to delete characters to the right of the cursor.
• Select Delete Line from the on-screen menu to remove the entire
line of text.
• Select Symbols from the on-screen menu to enter special
characters. See “Symbols” on page 20.
• Press the Tex t key to turn off text entry.
Arrow
1 Press the Arrow key.
Use the arrow as a pointer to bring attention to a specific part of the
image.
2 Use the touchpad to move the arrow over the image.
3 Press the Select key to switch the arrow’s orientation and then use the
touchpad to adjust the arrow’s orientation.
4 Press the Select key again to set the arrow’s orientation and then use
the touchpad to move the arrow over the image.
5 Press the Arrow key to set the arrow.
The arrow changes from green to white.
To remove the arrow from the image, press the Arrow key and then
select Hide from the on-screen menu.
To Next Page
Loading...
