Sony MVS-6000 - Page 162

162
Key Setting Operations Using Menus
Chapter 4 Keys
When drop border or shadow is selected: The setting parameter values
depend on the on/off setting of key drop and the selection of 4H mode/
8H mode (see page 144).
• “Key drop OFF” mode
• “Key drop ON” mode
a) In the “4H mode” and when [Fine Key] (page 163) is on, the setting value range is 0.00
to 4.00.
When emboss is selected:
a) The Density adjustment only affects the key edge. This can be adjusted separately from
Key Density, and if Key Density is set to 0.00, the embossed edge effect only can be
applied.
To make edge fill adjustments, carry out the settings in step 6.
4 Press [Edge Matte], and adjust the color parameters for the edge fill signal.
When the edge type is outline, in place of the edge fill signal, the selected
key fill signal fills the outline, and elsewhere remains as the background.
Press [Matte Adjust] to display the Matte Adjust menu, and carry out the
color matte adjustment for a single color or two-color combination. Select
Knob Parameter Adjustment Setting values
1 Width Width 0.00 to 8.00
2 Position Position 359.99 to 180.00
3 Density Density 0.00 to 100.00
Knob Parameter Adjustment Setting values
1Width Width
0.00 to 8.00
a)
2 Position Position 359.99 to 0.00
3 Density Density 0.00 to 100.00
Knob Parameter Adjustment Setting values
1 Width Width 0.00 to 4.00
2 Position Position 359.99 to 0.00
3
Density
a)
Density 0.00 to 100.00
Knob Parameter Adjustment Setting values
1 Luminance Luminance 0.00 to 100.00
2 Saturation Saturation 0.00 to 100.00
3 Hue Hue 359.99 to 0.00