203Basic Procedure for Wipe Settings
Chapter 5 Wipes
Modifying the wipe pattern edge (Edge)
You can apply a border to the pattern, soften the edges, or soften the applied
border.
Border: You can adjust the border width.
Soft: You can adjust the edge softness.
Soft border: You can adjust the border width, and the softness of the inner and
outer edges of the border.
When a border or soft border is selected, the signal filling the border is called
edge fill. For the edge fill, you can use a matte generated by the dedicated color
matte generator, or the signal selected on the utility bus. A matte can be color
1 or color 2, or a combination of the two colors (a “color mix”).
1
In the M/E-1 >Wipe menu, select HF4 ‘Edge/Direction.’
The Edge/Direction menu appears.
2
In the <Edge> group, select the edge type.
Border: border
Soft: soft edge
Soft Border: soft border
3
Set the parameters according to the selection in step 2.
• When border is selected
• When soft edge is selected
• When soft border is selected
Border
Soft
Soft border
Knob Parameter Adjustment Setting values
1 Width Border width 0.00 to 100.00
Knob Parameter Adjustment Setting values
1 Soft Edge softness 0.00 to 100.00
To Next Page
Loading...
