358
Simple P/P Software
Chapter 10 Special Functions
• A processed key cannot be used. Therefore, it is not possible to apply a DME
effect to a downstream key.
• As an independent key transition type, wipe and DME wipe cannot be used.
• The resizer cannot be used.
• The key frame delay mode cannot be used.
Restrictions on executing transitions in the transition control
block
• Wipes can be used, but there are restrictions on use. For details, see the next
item, “Restrictions when using wipes.”
• You can use a DME wipe for a background transition only. For details, see
“Restrictions when using DME wipes” (page 358).
Restrictions when using wipes
• The wipe patterns that can be used are pattern numbers 1 to 24 only.
• When a border or soft border is selected for a wipe edge, the signal to be
inserted in the edge (edge fill) is restricted as follows.
– The utility bus cannot be selected.
– When using a matte, a mix color cannot be used.
Restrictions when using DME wipes
• You can use a DME wipe for a background transition only.
• The patterns that can be selected are as follows. (One-channel patterns only)
Slide/Squeeze: slide and squeeze
Door: door
Flip Tumble: flip tumble
Frame I/O/P in P: frame in-out, picture-in-picture
Mosaic/Defocus: mosaic and defocus
Brick: brick
Notes
• For flip tumble, the background is filled with the same color as the wipe
border matte (single color).
• Door patterns 1045 to 1048 cannot be used.
Restrictions on utility buses
The utility bus cannot be used.
To Next Page
Loading...
