Sony SLV-360 - Page 93

3-18. MAIN SLIDER (Fig. 3-20)
}) Remove timing belt. (Refer to 3-3.)
2) Remove CAP brake assembly. (Refer to 3-4.)
3) Remove cam motor chassis block assembly. (Refer to 3-16.)
4) Remove screw @ to remove retainer @.
5) Pull out main slider ©.
[Note on Mounting]
* Apply FLOIL SG-055G (Jig Ref. No. J-12) as shown in Fig. A.
+ At the last, slide main slider fully in the arrow @ direction.
Each 3 drops
(Wall surface) a aINPs
Bottom side 1/2 drop(Apply to
outside position)
ra
Each 3 drops ‘
(Bpth wall surface) ~.
Apply grease all over the gear
(Apply until inside of gear)
@ Screw (3 x 8)
3 drops 3 drops
(Wall surface) Apply to wall surface @ Retainer \
Fig. A
Fig. 3-20