SPI Lasers redPOWER QUBE - 11.3.2 Laser ON; Process Cycle Active (Output Function ID 2)

© 2016 SPI Lasers UK Ltd.
Commercial in Confidence
SM-S00500 Revision A 21 October 2016
redPOWER QUBE Cased Fiber Laser User Manual
108
o Operational in both Local and Remote Control.
 Detailed Function Description
o This output function is used to indicate when the state is the STANDBY state. It
will not be SET until the emission indication time (5s) has expired, following a
Laser Start command from either a configured Machine Interface Laser Start
input function, or a Laser STANDBY serial command message.
o The output function will also be SET when the state is the ON state, or a
Process Cycle is active.
o The output function is CLEAR when the state is the OFF state or STARTING
state.
o This function can be assigned to any of the seven outputs.
o Associated functions
 Laser Start - Input Function
 Sequence diagrams
o See Figure 37 to Figure 66 for example functionality.
11.3.2 Laser ON / Process Cycle Active (Output Function ID 2):
 Default connection
o PL5 pin number 7
o Output number 1
 Basic Function Description
o SET when the state is the RAMPING state or the ON state, or a Process Cycle
is active.
o CLEAR when the state is in the STANDBY state or the OFF state.
o Operational in both Local and Remote Control.
 Detailed Function Description
o This output function is used to indicate when the state is the ON state or
RAMPING state in Parameter Sets mode or a Process Cycle is active in
Process Cycle mode.
o The operation of the function is subtly different depending on whether the
QUBE Fiber Laser is operating in Parameter Set mode, or Process Cycles
mode as follows:
a) Parameter Sets mode:
 This output function will be SET following a Laser ON command from either a
configured Machine Interface Laser ON input function (SET under Remote Control), or
a Laser ON serial command message.