© 2016 SPI Lasers UK Ltd.
Commercial in Confidence
SM-S00500 Revision A 21 October 2016
redPOWER QUBE Cased Fiber Laser User Manual
Figure 33 shows Steps grouped into Process Cycles. The Process Cycles contain from one to
16 Steps.
Figure 33 Steps Grouped Into Process Cycles
A 16 character name is stored with each active Process Cycle to allow it to be identified. For
example, the name of the Process Cycle could be the name of the part the Process Cycle has
been developed to process.
Process Cycle Steps determine the sequence of Parameter Sets that are executed, along
with their timing and transition type. All of the other information required to specify the output
is determined by the Parameter Set.
To edit a Process Cycle select by Process Cycle Tab, or View – Windows – Process Cycle
Editor on Menu Bar.
The Process Cycle Steps contain the attributes listed in Table 15. The attributes can be
assigned to each Step using the Process Cycle editor, as shown in Figure 34.
Figure 34 FiberView Process Cycle Editor
To Next Page
Loading...