Stelpro ASMC402 - DEACTIVATING THE ZIGBEE NETWORK FROM A CONTROLLER• THERMOSTAT

- 41 -- 41 -
DEACTIVATING THE ZIGBEE NETWORK FROM A CONTROLLER
•
THERMOSTAT
To re-build your network without losing your home congurations (groups, activities, Wi-Fi, etc.), you must rst deactivate the
Zigbee network on your controller
•
thermostat.
1 - Access SETTINGS > ZIGBEE SETUP > LEAVE NETWORK.
2 - Tap YES to conrm the deactivation.
IMPORTANT : When the Zigbee network is deactivated, all the thermostats connected to it will disconnect. You will need
to connect them to the controller
•
thermostat’s Zigbee network to control them from the controller
•
thermostat and from
the MAESTRO app. Depending on their location in the home, some thermostats may not disconnect automatically when
the Zigbee network is deactivated. In this case, you must disconnect the thermostat from the network on the thermostat
in question.
3 - Once the Zigbee network has been deactivated, tap END to save the changes.
LEAVE
NETWORK
YES
Are you sure?