Stelpro ASMC402 - WHERE TO INSTALL YOUR MAESTRO CONTROLLER•THERMOSTAT

- 7 -- 7 -
WHERE TO INSTALL YOUR MAESTRO CONTROLLER
•
THERMOSTAT
The controller
•
thermostat allows you to control the other MAESTRO thermostats in your home. Install it in a room that is
central, for example the main living area of your home, where it will be easily accessible. Since the controller
•
thermostat also
serves as a thermostat, it will control the temperature of this room.
You must install the controller
•
thermostat at approximately 5 ft. from the oor, on an indoor wall that faces the heating system.
The controller
•
thermostat must be mounted on an electrical box.
ATTENTION : To avoid any risk of overheating, leave a clearance of at least 12 in. around the controller
•
thermostat to ensure
proper ventilation. Also, the front of the unit should be completely clear of any obstruction to ensure optimal functionality. For
example, do not install the controller
•
thermostat behind curtains or furniture.
To avoid getting false temperature measurements, do not install the controller
•
thermostat in any of the following locations:
• Near a window or close to a door leading outside
• In an area exposed directly to the light or heat of the sun, a lamp, a replace or any other heat source
• Near an air outlet
• Near concealed ducts or a chimney
• Where there is poor air ow (e.g. behind a door)
• Where there is a high concentration of dust
• Where there are frequent air drafts (e.g. top of stairs)
5 ft.