1-3
Safety Precautions Operator Manual 10083002
Do not remove monitor-arm safety pin until monitor is installed.
Monitor extension arm must have monitor (or equivalent counterweight) installed to keep arm in required
positions while installing sliding guards.
Do not modify this equipment without authorization of the manufacturer.
WARNING – STERILITY ASSURANCE HAZARD:
During surgical procedure, do not use the surgeon’s control buttons unless a disposable sterile cover is
installed. If the sterilizable lighthandle (metal, provided with lighthead) is used without a disposable cover,
the surgeon’s control buttons are not protected by a sterile covering.
Do not use disposable handle covers if its packaging has been damaged, torn or opened; as the sterility of
the cover may be compromised.
CAUTION – POSSIBLE EQUIPMENT DAMAGE HAZARD:
Cleaning and disinfecting agents used on this lighting system must be certified by their manufacturer to be
compatible with the following materials: polycarbonate, polyetherimide, santoprene.
Use only recommended cleaning/disinfecting and/or anti-static agents on this light. Some degree of
staining, pitting and/or discoloration could occur if a phenolic-, iodophor- or glutaraldehyde-based
disinfectant is used on the surfaces of this lighthead. Also, use of alcohol or aerosol spray cleaner/
disinfectants containing a substantial amount of alcohol in the formula can damage the polycarbonate
lens.
Use of any disinfectant solution OTHER than those listed here may cause discoloration or deformation on
the lens surface: Coverage
®
Plus Germicidal Surface Wipes Disinfecting/Deodorizing/Cleaning Wipes.
Cleaning solutions other than those listed have NOT been tested for compatibility or effectiveness. Always
follow manufacturer instructions for concentrations and use of cleaning products.
DO NOT SPRAY any cleaning product directly onto the lighthead or any system components. Dampen a
soft cloth with the cleaning solution and wring out the excess moisture.
Do not scratch the lens when cleaning; always wear rubber gloves and use only a clean, white, lint-free
cloth when wiping external surfaces.
The camera module tends to roll if placed on a flat surface. Camera must be cradled in a carton, tray or
similar item when not in use or when transported.
Avoid damage to lighthead. Standard definition (SD) and high-definition (HD) connectors are not
compatible. Do not force a SD camera module into lighthead receptacle for a HD camera module.
Prevent leakage of fluids into interior of lighthead or control center.
Avoid discoloration of control center keypad and display. Do not clean control center with povidone-iodine
solutions or allow such solutions to contact keypad and display surfaces.
WARNING – PERSONAL INJURY HAZARD: (CONTINUED)
To Next Page
Loading...
