Steris Harmony LED Wall Control Unit - 5.13 System Standby; Ambient Light Fixture; Ambient Light Operation Overview; Figure 5-19. System Standby Screen

5-26
10083002 Operator Manual Operating Instructions
5.13 System Standby The screen shown in Figure 5-19 is displayed when the control
center has been placed in Standby mode. The screen displays
“SYSTEM STANDBY” text and international symbol for a system in
standby mode.
5.14 Ambient Light
Fixture
The LED ambient light fixture accessory can be installed at the time
the Harmony lighting system is installed, or can be added later to a
previously installed system.
5.14.1 Ambient Light
Operation Overview
The ambient light provides low-level, general illumination in the
surgical suite. Illumination from the ambient light fixture can be
configured to operate manually (turned on or off at the Harmony
Control Center), or the ambient light can be configured to operate
automatically (turns off when any system lighthead is turned on and
turns on when all system lightheads are turned off). When configured
for automatic operation, the ambient light can still be manually
turned on or off at the control center.
Figure 5-19. System Standby Screen