Steris Harmony LED Wall Control Unit - Waste Management Guidelines

10-1
Waste Management Guidelines Operator Manual 10083002
The following materials are contained within the HarmonyAIR™
Surgical Lighting System M Series with Harmony
®
LED Wall Control
Unit. When disposing of the EMS or its parts, ensure proper disposal
of hazardous and other regulated waste in compliance with national,
state and local WEEE/RoHS regulations.
Electronic and Electrical Parts – not known to require special
disposal methods at date of this manual.
Metal Parts – made from aluminum (Al), steel (Fe), cast iron (Fe),
copper (Cu), and copper alloys (Cu/x), plastic, synthetic rubber,
plating (Cr, Ni, Zn, Au), and adhesives not known to require special
disposal methods at date of this manual.
Polyvinylchloride (PVC) – The approximate weight of PVC within an
LED system varies with configuration and options, ranging between
1.8 lb (0.9 kg) and 6.6 lb (3.0 kg).
WASTE MANAGEMENT GUIDELINES
10