EasyManua.ls Logo

Steris Harmony LED Wall Control Unit - Cleaning the Equipment; Cleaning Equipment

Steris Harmony LED Wall Control Unit
74 pages
Print Icon
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
6-1
Cleaning the Equipment Operator Manual 10083002
6.1 Cleaning
Equipment
•Pail
Sponge
Cloth Wipes (lint free)
Rubber Gloves
Mild Household Detergent (e.g., Dishwashing Liquid)
Disinfectant cleaners such as: Coverage
®
Plus Germicidal
Surface Wipes Disinfecting/Deodorizing/Cleaning Wipes
(available from STERIS).
WARNING – PERSONAL INJURY
HAZARD: Do not attempt to clean
lighthead unless power is turned
off and the lighthead has cooled
sufficiently.
CAUTION – POSSIBLE
EQUIPMENT DAMAGE HAZARD:
Use of any disinfectant
solution OTHER than those
listed here may cause
discoloration or deformation
on the lens surface:
Coverage
®
Plus Germicidal
Surface Wipes Disinfecting/
Deodorizing/Cleaning Wipes.
Cleaning solutions other than
those listed have NOT been
tested for compatibility or
effectiveness. Always follow
manufacturer instructions for
concentrations and use of
cleaning products.
Avoid discoloration of control
center keypad and display. Do
not clean control center with
povidone-iodine solutions or
allow such solutions to
contact keypad and display
surfaces.
Prevent leakage of fluids into
interior of lighthead or control
center.
Cleaning and disinfecting
agents used on this lighting
system must be certified by
their manufacturer to be
compatible with the following
materials: polycarbonate,
polyetherimide, santoprene.
DO NOT SPRAY any cleaning
product directly onto the
lighthead, modem chassis, or
any system components.
Dampen a soft cloth with the
cleaning solution and wring
out the excess moisture.
!
!
CLEANING THE EQUIPMENT
6

Table of Contents

Related product manuals