Stihl Cutquik TS 460 - Page 15

STIHL TS 460 15
Top:
Flange Top: Top:
mounting screws 1 = Deep groove ball bearing Correctly positioned spring washers
2 = Ring
Bottom: Bottom:
Fitting the circlip Bottom: Longer collar on the
with pliers 0811 641 8380 Pressing in the deep groove ball bearings V-belt pulley
- Unscrew the flange mounting - Slide the first deep groove ball - Slide the same number of spring
- screws and remove the flage - bearing onto the shaft, then the - washers onto the flat head
- from the guard. - ring and the second deepgroove - screws as were removed during
- ball bearing. - disassembly, as shown in the
The parts are assembled in - drawing.
reverse order. - Position the deep groove ball
- bearings and press them in with - Slip the V-belt pulley onto the
Note: Particular care must be
- the shaft until they contact the - shaft with the longer chamfered
taken when carrying out the - circlip. - edge first and tighten the nut with
following work. - a torque of 37.5 Nm.
- Draw the shaft out of the deep
- Place the circlip in one of the - groove ball bearings.
- bearing grooves.
- Place the second circlip in the
- bearing groove.