Stihl Cutquik TS 460 - Page 70

STIHL TS 460 70
Top:
Mounting the throttle shutter
1 = Round notch
2 = Notches
Bottom:
Choke shutter mounting screws
Top:
1 = Circlip
2 = Ring
Bottom:
Removing the choke shaft
Top:
1 = Gasket
2 = Torsion spring
Bottom:
Choke lever mounting bolt
- Mount throttle shutter with
round notch toward control-
side end cover and other
notches facing inward.
- Screw in mounting screw
using Loctite, see 11.2., and
tighten.
Removing the choke shaft
- Unscrew choke shutter
mounting screws, remove
choke shutter.
- Press circlip off of choke
shaft.
- Remove ring and gasket.
- Remove choke shaft from
carburetor.
- Remove torsion spring and
gasket.
- Unscrew choke lever mounting
screw, remove choke lever.