5 Operation
Battery
– Disconnect the battery male connector; see
chapter "Charging the battery".
– Batteries with open terminals or connectors
must be covered with a rubber mat to
prevent short circuits.
Disconnecting the battery
– Attach a suitable hoist to t
he battery.
– Adjust the length of the hoist so that it is
vertically above the battery's centre of
gravity.
– Lift the battery clear of the truck.
– Set the battery down care
fully.
The ground must be capable of bearing the
weight of the battery.
– Do not place the lifting gear on the battery
cells or allow it to fall on them.
– Transport the battery to
the intended
storage space.
– Set down the battery.
94 1
72780 EN - 06/2017
To Next Page
Loading...
Need help?
General
