Operation 5
Drive mode
127-28
Running the truck in
The truck can be operated at maximum speed
immediately after delivery. However, avoid
continuous high loads during the first 50
operating hours.
Checking the wheel nuts
WARNING
Risk of accident from loose wheel nuts!
Within the first 50 operating hours of receiving the
truck or after changing a wheel, it is IMPERATIVE
to check the tightening torques of the wheel nuts
and to check that they are complete and securely
fitted.
– Check that the wheel nuts are complete and
securely fitted.
– Check the wheel nuts for the correct tightening
torques.
– Tighten the wheel nuts crosswise with a torque
of 195 Nm.
NOTE
If it is found necessary to tighten the wheel
bolts to the correct torque, then they must be
checked again after 50 hours. Repeat the
tightening procedure every 50 hours until the
correct torque is consistently obtained.
Selecting the drive programme
NOTE
As an option, the operating lever can be
located on the left-hand side of the steering
column
Operating stage Operating lever
Normal speed "Hare" position
Slow speed "Tortoise" position
.
172
780 EN - 06/2017 77
To Next Page
Loading...
Need help?
General
